THE
CRO GROUP, INC.
MEDICAL DEVICE, IVD, & BIOTECHNOLOGY CONSULTANTS

  [ Feedback ] [ Search ] [ Featured Products ] [ StdsRadar ] [ Employment ] icon

 

Home
Up

 

CiteLineAwd.GIF (5212 bytes)

Banner 10000090

mie_120x60

 

 

Getting Started on Electrical Safety and EMC

To be able to meet a portion of the requirements of the electrical medical standards (IEC60601-1 or other 601-1 based national standards) the first step you should do as you are designing a medical device is to generate an isolation diagram of the product. The term isolation or insulation diagram is used interchangeably. An isolation diagram is a GREAT tool to communicate spacings and dielectric requirements of the standards to the designers of the product. You may also be able to identify alternative ways to meet the requirements and therefore design the product at a lower cost or make it easier to manufacture which could also save money and time. If you get to the Agency evaluation of the product and you haven’t conducted this step you may be out of luck and need to re-design the product which is very costly in time and money and you could lose your market advantage.

isolatioindiagram.gif (8553 bytes) An isolation diagram indicates how the patient is isolated from the mains and secondary circuits of the product. There are quite a few additional areas of concern for a product in terms of meeting insulation requirements, other than patient & circuit isolation but patient isolation is critical to a design. The isolation diagram proves that you have two levels of protection available so if a single fault occurs the user or patient will be safe from an electrical shock hazard or another type of hazard.

A good reason for an isolation diagram is that this diagram is a good block diagram that can show some general information about the product without extensive schematics that many non-technical people can understand more readily. Therefore, you can use this tool to meet many needs instead of just to meet the Safety Agency Requirements.   If you would like to talk to a CRO Group engineer about how to prepare an insulation diagram for your new design, please contact us by clicking here.   This page was prepared and provided by Leonard Eisner, of affiliate organization Eisner Safety Consultants.

Copyright © 1996 - 2005 The CRO Group Inc.   All rights reserved.